This guide will walk you through the process of replacing the LED display on your scooter. It is a fairly simple task that does not require much special knowledge. Please note that this guide is for the S10 model specifically.

Remove the Display

Step 1: Turn off the scooter and unclamp the handlebar stem quick-release lever to lower the handlebar. Then using a 4mm Allen key to remove the 4 screws at the bottom of the display base. 
Note: When loosening the screws, be careful not to let the handlebar fall down to the ground.

Step 2: Unplug the connector that goes from the display, and remove the display from the handlebar. The connector is near the handlebar.
Note: To unplug the display connector, hold and pull the connector halves apart directly, do not twist or turn them. Improper operation can give rise to wire damages inside.

Install the New Display

Step 1: Attach the handlebar to the stem connection, and put the LCD display block on by threading its two outgoing wires through the openings.

Step 2: Then thread in the four screws but do not tighten them fully.

Step 3: Set up the handlebar to your preference, make sure the handlebar is centered, then fully tighten the display base bolts in an X pattern.

NOTE: The handlebar has lateral striped markings to assist with its centering in the clamp. It is important to ensure the rim of markings is not laterally beyond the side edges of the handlebar clamp in this step.

Need additional help? Please reach the G-FORCE support team at: support@g-forcebike.com